AWestyNamedRowlf: ScanGauge II has arrived!

Wednesday, January 2, 2013

ScanGauge II has arrived!

Cool stuff - the Scangauge has arrived. I've plugged it in but have not really used it. This explains the network cable I found routing to the front dash.

Should be helpful to track down trouble-codes.

No comments:

Things to do!

Brakes

* [DONE] Brake retaining clip replacement

* Fuel filter replacement/fix (reorient)

* [DONE] Brake hose replacement

* [DONE] Bleed brakes (again and again)

* [DONE] New Master Cylinder (don't think it was needed)

* [DONE] New brake proportioning valve (not sure if needed)

* [DONE] Add pipe thread tape to rear cylinder bleeder

Engine:

* [DONE] Fix vacuum hoses engine compartment

* [DONE] ScanGuageII for engine diagnostics

* [DONE] New fuel line hose to engine 2.5.13

* [DONE] Engine computer wires

* Engine check light (and all other lights too)

* [DONE] Clutch slave line needs clamp to hold in place

* [DONE] Strengthen and check wiring in harness.

* [DONE] New wiring to fuel pump + ground

Interior:

* [DONE] Tachometer

* Dashboard lights

* AC

* [DONE] Stove dial knob

* Propane tank check

*[DONE] Fridge is lopsided

* [DONE] Shoulder belt installation

* [DONE] Removed interior! Kitchen is out!

Body:

* [DONE] Paint!

* [DONE] Relocate spare tire

* [DONE] New radio

* [DONE] Rewiring house battery (ok, almost done)

* [DONE] Investigate any rust issues

* [DONE] New windshield wipers front/rear

* [DONE] Rear windshield wiper not work

* [DONE] Missing screw on drivers side reflector (and many others)

* [DONE] Rusty carriage bolts on camper top

* [DONE] Bumpers are slightly bent - easy fix

AWestyNamedRowlf

Wednesday, January 2, 2013

ScanGauge II has arrived!

No comments:

Post a Comment

About Me